PANORAMIC VIEW MONITOR SYSTEM DATA LIST / ACTIVE TEST

  1. DATA LIST

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Connect the GTS to the DLC3.

    2. Start the engine.

    3. Turn the GTS on.

    4. Enter the following menus: Chassis / Panoramic View Monitor / Data List.

    5. According to the display on the GTS, read the Data List.

      Chassis > Panoramic View Monitor > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      AVC Master Connect Malfunction Record

      A history item indicating that no registration response was returned within 0.3 seconds after sending a parking assist ECU registration request

      Unrec/Rec

      Unrec: AVC-LAN communication is normal

      Rec: AVC-LAN communication is abnormal

      -

      AVC Master Reset Malfunction Record

      A history item indicating that, despite the parking assist ECU first registration request that was sent ending normally, no resend command was received from the master

      Unrec/Rec

      Unrec: AVC-LAN communication is normal

      Rec: AVC-LAN communication is abnormal

      -

      AVC Connect Confirmation Malfunction Record

      A history item indicating that no connection confirmation command was received from the navigation system for 70 seconds or more after registration or receiving the previous connection confirmation command

      Unrec/Rec

      Unrec: AVC-LAN communication is normal

      Rec: AVC-LAN communication is abnormal

      -

      AVC Sending Malfunction Record

      A history item indicating that a transmission malfunction, such as failed transmission to the navigation system, occurred after the engine switch is turned on (ACC)

      Unrec/Rec

      Unrec: AVC-LAN communication is normal

      Rec: AVC-LAN communication is abnormal

      -

      AVC Register Complete Reception Malfunction Record

      A history item indicating that a registration complete notification cannot be received from the navigation system

      Unrec/Rec

      Unrec: AVC-LAN communication is normal

      Rec: AVC-LAN communication is abnormal

      -

      AVC Register Request Sending Malfunction Record

      A history item indicating that a registration request was sent without receiving a registration command from the navigation system

      Unrec/Rec

      Unrec: AVC-LAN communication is normal

      Rec: AVC-LAN communication is abnormal

      -

      RHD/LHD Data Check

      Status of the RHD/LHD data check

      OK/NG

      OK: Parking assist ECU is normal

      NG: Parking assist ECU is abnormal

      -

      HV/ENG Data Check

      Status of the HV/ENG data check

      OK/NG

      OK: Parking assist ECU is normal

      NG: Parking assist ECU is abnormal

      -

      2WD/4WD Data Check

      Status of the 2WD/AWD data check

      OK/NG

      OK: Parking assist ECU is normal

      NG: Parking assist ECU is abnormal

      -

      AT/MT Data Check

      Status of the AT/MT data check

      OK/NG

      OK: Parking assist ECU is normal

      NG: Parking assist ECU is abnormal

      -

      Main CPU Forced Termination Detection Record

      A history item indicating that the main CPU did not enter standby status within 15 seconds of turning the engine switch off and a forced end was applied

      Unrec/Rec

      Unrec: Parking assist ECU is normal

      Rec: Parking assist ECU is abnormal

      -

      Main CPU Abnormal Response Record

      A history item indicating that the main CPU became unresponsive in normal status

      Unrec/Rec

      Unrec: Parking assist ECU is normal

      Rec: Parking assist ECU is abnormal

      -

      Main CPU Abnormal Reset Record

      A history item indicating that the main CPU was reset, although the engine switch was not turned off in normal status

      Unrec/Rec

      Unrec: Parking assist ECU is normal

      Rec: Parking assist ECU is abnormal

      -

      Image Processing IC Written Protect Record

      A history item indicating that the image processing IC memory was write protected

      Unrec/Rec

      Unrec: Parking assist ECU is normal

      Rec: Parking assist ECU is abnormal

      -

      Image Processing IC Initialized Malfunction Record

      A history item indicating that the image processing IC memory was not initialized

      Unrec/Rec

      Unrec: Parking assist ECU is normal

      Rec: Parking assist ECU is abnormal

      -

      Main EEPROM Access Status

      Main EEPROM access status

      OK/NG

      OK: Parking assist ECU is normal

      NG: Parking assist ECU is abnormal

      -

      Sub EEPROM Access Status

      Sub-EEPROM access status

      OK/NG

      OK: Parking assist ECU is normal

      NG: Parking assist ECU is abnormal

      -

      System Power Supply Voltage Malfunction Record

      A history item indicating an abnormally generated-voltage value from the system power source

      Unrec/Rec

      Unrec: Parking assist ECU is normal

      Rec: Parking assist ECU is abnormal

      -

      Main CPU Starting Malfunction Record

      A history item indicating that the main CPU did not start

      Unrec/Rec

      Unrec: Parking assist ECU is normal

      Rec: Parking assist ECU is abnormal

      -

      CAN CPU Boot Malfunction Record

      A history item indicating that the CPU controlling the input and output of the information obtained via the CAN communication system did not start and the information could not be retrieved

      Unrec/Rec

      Unrec: Parking assist ECU is normal

      Rec: Parking assist ECU is abnormal

      -

      Visual Display Line Status

      Displays the status of the video signals displayed on the multi-display

      OK/NG

      OK: GVIF cable is normal

      NG: GVIF cable is abnormal

      -

      Wheel Speed Sensor (4wheel)

      Reception state of the vehicle speed signal from the skid control ECU

      OK/NG

      OK: Speed signal received

      NG: Speed signal not received

      -

      Bus-off Continuation Detection Record

      A history item indicating that the bus off condition was detected

      Unrec/Rec

      Unrec: Parking assist ECU is normal

      Rec: Parking assist ECU is abnormal

      -

      Shift R Position

      Status of the shift R position

      OFF/ON

      OFF: Shift lever not in R

      ON: Shift lever in R

      -

      Camera Changing SW Signal Status

      Signal status at the BLSW terminal (switch camera signal)

      ON/OFF

      ON: Panoramic view monitor main switch on

      OFF: Panoramic view monitor main switch off

      -

      Image Adjustment Status

      Status of the image adjustment status

      Incomplete/Processing/Complete

      Incomplete: Image adjustment incomplete

      Processing: Image adjustment in processing

      Complete: Image adjustment completed

      -

      Number of DTC

      Number of DTCs (past and present)

      Min: 0, Max: 255

      Changes according to the number of DTCs output

      -