PRE-CRASH SAFETY SYSTEM TERMINALS OF ECU


  1. CHECK DRIVING SUPPORT ECU ASSEMBLY

    A005CQ7E03

    1. Disconnect the driving support ECU assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
      L60-5 (PBSW) - Body ground L - Body ground Pre-crash brake cancel switch Pre-crash brake cancel switch assembly on Below 1 Ω
      Pre-crash brake cancel switch assembly off 10 kΩ or higher
      L60-23 (CCS) - L60-25 (GND) V - W-B Cruise control main switch signal Power switch on (IG) 1 MΩ or higher
      L60-23 (CCS) - L60-25 (GND) V - W-B Cruise control main switch signal

      Power switch on (IG),

      CANCEL switch on

      		 1509 to 1571 Ω
      L60-23 (CCS) - L60-25 (GND) V - W-B Cruise control main switch signal

      Power switch on (IG),

      -/SET switch on

      		 617 to 643 Ω
      L60-23 (CCS) - L60-25 (GND) V - W-B Cruise control main switch signal

      Power switch on (IG),

      +/RES switch on

      		 235 to 245 Ω
      L60-23 (CCS) - L60-25 (GND) V - W-B Cruise control main switch signal

      Power switch on (IG),

      Main switch on

      		 Below 2.5 Ω
      L60-25 (GND) - Body ground W-B - Body ground Body ground Always Below 1 Ω

      If the result is not as specified, there may be a malfunction on the wire harness side.

    3. Reconnect the connector.

    4. Measure the voltage according to the value(s) in the table below.

      Terminal No. (Symbols) Wiring Color Terminal Description Condition Specified Condition
      L60-7 (MODE) - Body ground R - Body ground MODE signal

      Power switch on (IG)

      MODE switch off

      		 11 to 14 V

      Power switch on (IG)

      MODE switch on

      		 Below 2 V
      L60-17 (CA2L) - L60-25 (GND) R - W-B CAN communication signal Power switch on (IG)

      Pulse generation

      (See waveform 1)
      L60-39 (CA2H) - L60-25 (GND) B - W-B CAN communication signal Power switch on (IG)

      Pulse generation

      (See waveform 2)
    5. A005DADE01

      Waveform 1


      1. CAN communication signal

        Item Content
        Driving Support ECU Assembly Terminal Name Between CA2L and GND
        Tester Range 1 V/DIV., 10 μsec./DIV.
        Condition Power switch on (IG)

        Tech Tips

        The waveform varies depending on the CAN communication signal.

    6. A005CP3E07

      Waveform 2


      1. CAN communication signal

        Item Content
        Driving Support ECU Assembly Terminal Name Between CA2H and GND
        Tester Range 1 V/DIV., 10 μsec./DIV.
        Condition Power switch on (IG)

        Tech Tips

        The waveform varies depending on the CAN communication signal.