HEIGHT CONTROL SENSOR INSPECTION

PROCEDURE

  1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY

    E184275E08
    Note:

    Do not drop the height control sensor. If it is dropped, replace it with a new one.

    1. Connect 3 dry batteries of 1.5 V in series.

    2. Connect the positive (+) end of the batteries to terminal 3 (VCC) of the height control sensor and the negative (-) end of the batteries to terminal 1 (GND).

      Note:

      Do not apply a voltage of higher than 6 V.

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection

      Condition

      Specified Condition

      2 (OUT) - 1 (GND)

      Max. high

      Approx. 4.5 V

      Normal

      Approx. 2.5 V

      Min. low

      Approx. 0.5 V

      If the result is not as specified, replace the rear height control sensor sub-assembly.