CAMSHAFT OIL CONTROL VALVE(for Intake Side) INSTALLATION

PROCEDURE


  1. SET NO. 1 CYLINDER TO TDC/COMPRESSION

    Click here

  2. INSTALL CAMSHAFT TIMING GEAR BOLT


    1. B0086MX

      Apply engine oil to the areas of the camshaft timing gear bolt shown in the illustration.

    2. Temporarily install the camshaft timing gear bolt to the camshaft timing gear assembly.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      If the camshaft timing gear bolt has been struck or dropped, replace it.

      Tech Tips

      Make sure that the flange part of the camshaft timing gear bolt contacts the entire circumference of the camshaft timing gear assembly.

    3. Loosen the camshaft timing gear bolt 60 to 180°.

    4. Turn the crankshaft pulley clockwise 60 to 120°.

    5. While holding the crankshaft pulley set bolt, tighten the camshaft timing gear bolt.

      Torque:
      95 N*m  { 969 kgf*cm, 70 ft.*lbf }

    6. Engage the clamp to connect the engine wire.

  3. INSTALL CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY

    Click here

  4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  5. INSTALL FRONT FENDER APRON SEAL RH

    Click here

  6. INSPECT FOR ENGINE OIL LEAK

    Click here