TRANSMISSION CONTROL CABLE INSTALLATION

INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

Pass the transmission control cable assembly into the vehicle and install the transmission control cable assembly to the vehicle body with the 2 nuts.

5.0 N*m

51 kgf*cm

44 in.*lbf
Connect the transmission control cable assembly to the rear engine mounting insulator with the bolt.

5.0 N*m

51 kgf*cm

44 in.*lbf
Connect the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.

*a	P Position
*b	N Position

Turn the control shaft lever clockwise until it stops, then turn it counterclockwise 2 notches.

Connect the transmission control cable assembly to the control shaft lever with the nut.

12 N*m

122 kgf*cm

9 ft.*lbf

Turn the nut of the transmission control cable assembly approximately 180° counterclockwise. While holding the nut in place, push in the stopper until it clicks twice.

*a	Stopper	*b	Nut
*c	Push in	*d	Turn approximately 180°

Tip:

If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.

Connect the transmission control cable assembly to the shift lever assembly. Check that the spring is positioned at (A) and push in the stopper.

*1	Transmission Floor Shift Assembly	-	-
*a	Stopper	*b	Spring
*c	Nut	*d	Push in

Note:

If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.
Make sure that the transmission control cable assembly is securely locked.

Confirm that the shift lever is in N, and then install the end of the transmission control cable assembly to the transmission floor shift assembly.
Note:
- Securely install the end of the transmission control cable assembly to the transmission floor shift assembly.
- Install the end of the transmission control cable assembly so that its adjustment lock section is on the driver side.