REAR SEAT SIDE AIRBAG ASSEMBLY(for Power Seat) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR SEAT AIRBAG ASSEMBLY LH


    1. B006FDC

      Install the rear seat airbag assembly LH with 2 new nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      CAUTION:


      • Do not reuse the nut.

      • If the installation surface or surrounding area of the rear seat airbag assembly LH is deformed or damaged, replace the rear seat sub panel sub-assembly LH with a new one.

    2. Attach the claw to connect the airbag connector.

  2. INSTALL SEPARATE TYPE REAR SEATBACK COVER WITH PAD LH

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  5. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  6. CHECK SRS WARNING LIGHT

    Click here