IMMOBILISER SYSTEM(w/ Entry and Start System), Diagnostic DTC:B2779

DTC Code DTC Name
B2779 Engine Starter Communication Malfunction

DESCRIPTION

When an internal malfunction occurs in the certification ECU (smart key ECU assembly), the certification ECU (smart key ECU assembly) stores this DTC.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Note

B2779

Engine Starter Communication Malfunction

An internal malfunction occurs in the certification ECU (smart key ECU assembly).

Certification ECU (smart key ECU assembly)

DTC output confirmation operation:

  • Always

Table 1. Vehicle Condition and Fail-safe Operation when Malfunction Detected

Vehicle Condition when Malfunction Detected

Fail-safe Operation when Malfunction Detected

-

-

Table 2. Related Data List and Active Test

DTC No.

Data List and Active Test

B2779

-

CAUTION / NOTICE / HINT

Note:
  • When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

  • Before performing the inspection, check that DTC B1242 (wireless door lock control) is not output.

  • Before replacing the certification ECU (smart key ECU assembly), refer to Service Bulletin.

  • After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".

PROCEDURE

  1. CLEAR DTC

    1. Clear the DTCs.

      Body Electrical > Entry&Start > Clear DTCs

    Result

    Proceed to

    NEXT

    NEXT
  2. CHECK DTC OUTPUT

    1. Check for DTCs.

      Body Electrical > Entry&Start > Trouble Codes

      OK

      DTC B2779 is not output.

    Result

    Proceed to

    OK

    NG

    OK

    USE SIMULATION METHOD TO CHECK

    NG

    REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)