ULTRASONIC SENSOR(for Sedan Rear Side) INSTALLATION

PROCEDURE

  1. INSTALL NO. 3 ULTRASONIC SENSOR RETAINER

    1. E275142C01

      *a

      Protrusion

      *b

      Cutout

      Install the No. 3 ultrasonic sensor retainer to the rear bumper assembly.

      Note:

      • Do not damage the rear bumper assembly with the protrusion when installing the No. 3 ultrasonic sensor retainer.

      • Securely install the No. 3 ultrasonic sensor retainer so that there are no gaps between the No. 3 ultrasonic sensor retainer and surface of the rear bumper assembly.

      Tip:

      • When installing the No. 3 ultrasonic sensor retainer, align the cutout and protrusion as shown in the illustration.

      • This illustration is for the corner sensor LH side or back sensor. The orientation for the corner sensor RH side is the opposite of the corner sensor LH side and back sensor.

      • Use the same procedure for all No. 3 ultrasonic sensor retainers.

  2. INSTALL ULTRASONIC SENSOR CLIP

    Tip:

    Use the same procedure for all ultrasonic sensor clips.

    1. Engage the 2 claws to install the ultrasonic sensor clip.

  3. INSTALL NO. 3 ULTRASONIC SENSOR

    Tip:

    Use the same procedure for all No. 3 ultrasonic sensors.

    1. Engage the 2 claws to install the No. 3 ultrasonic sensor.

    2. Connect the connector.

    3. Engage the clamp.

  4. INSTALL REAR BUMPER ASSEMBLY

    Click here