MANUAL TRANSAXLE OIL REPLACEMENT

PROCEDURE

1. REMOVE ENGINE UNDER COVER

   1. 

      Remove the 9 clips and fold back the engine under cover.

      Tip:

      It is not necessary to fully remove the engine under cover. Partially remove it so that the oil can be replaced in a later step.

2. REMOVE REAR ENGINE UNDER COVER LH

   Click here

3. DRAIN MANUAL TRANSAXLE OIL

   1. 

      Remove the filler plug and gasket.

      Table 1. Text in Illustration

      *1	Filler Plug

   2. Using a 10 mm hexagon socket wrench, remove the drain plug and gasket to drain the manual transaxle oil.

      Table 2. Text in Illustration

      *2	Drain Plug

   3. Using a 10 mm hexagon socket wrench, install the drain plug and a new gasket.

      45 N*m

      459 kgf*cm

      33 ft.*lbf

4. ADD MANUAL TRANSAXLE OIL

   1. 

      Add oil until the oil level is within 5 mm (0.197 in.) from the bottom of the transmission filler plug opening.

      Manual Transaxle Oil

      "Toyota Genuine Manual Transmission Gear Oil LV" or "API GL-4 and SAE 75W"

      Standard Capacity

      2.4 liters (2.5 US qts, 2.1 Imp. qts)

   2. Install a new gasket and the transmission filler plug.

      39 N*m

      400 kgf*cm

      29 ft.*lbf

      Note:

      • When adding transaxle oil, make sure the vehicle is level.

      • An excessively large or small amount of oil may cause problems.

5. INSPECT FOR OIL LEAK

6. INSTALL REAR ENGINE UNDER COVER LH

   Click here

7. INSTALL ENGINE UNDER COVER

   1. 

      Install the engine under cover with the 9 clips.