REAR COMBINATION LIGHT ASSEMBLY DISASSEMBLY

PROCEDURE


  1. REMOVE REAR COMBINATION LIGHT BODY GASKET


    1. A005B4K

      Remove the 2 rear combination light body gaskets.

      Note


      • Be sure to remove all the traces of the old gaskets from the body.

      • Do not reuse the removed gaskets. Be sure to install new rear combination light body gaskets to prevent water ingress.

  2. REMOVE REAR COMBINATION LIGHT GASKET


    1. A005DEF

      Remove the rear combination light gasket.

      Note


      • Be sure to remove all the traces of the old gasket from the body.

      • Do not reuse the removed gasket. Be sure to install a new rear combination light gasket to prevent water ingress.

  3. REMOVE REAR TURN SIGNAL LIGHT BULB


    1. A005EN7

      Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb in the direction indicated by the arrow shown in the illustration, and disconnect them as a unit.

    2. Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.

  4. REMOVE REAR NO. 1 FOG LIGHT BULB (for LH Side)


    1. A005D60

      Turn the rear combination light socket and wire sub-assembly with the rear No. 1 fog light blub in the direction indicated by the arrow shown in the illustration, and disconnect them as a unit.

    2. Remove the rear No. 1 fog light blub from the rear combination light socket and wire sub-assembly.

  5. REMOVE BACK-UP LIGHT BULB (for RH Side)


    1. A005DR4

      Turn the rear combination light socket and wire sub-assembly with the back-up light bulb in the direction indicated by the arrow shown in the illustration, and disconnect them as a unit.

    2. Remove the back-up light bulb from the rear combination light socket and wire sub-assembly.

  6. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY


    1. A005D6S

      Disconnect the connector.

    2. Disengage the claw and remove the rear combination light socket and wire sub-assembly.