HOOD LOCK CONTROL CABLE ASSEMBLY(for RHD) INSTALLATION

PROCEDURE

  1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

    1. B277362C05
      Table 1. Text in Illustration

      *1

      String

      Tie the string that was passed through the engine compartment room to the end of the hood lock control cable assembly as shown in the illustration.

      Tip:

      Use a length of string long enough to pass through the engine compartment room.

    2. Pass the hood lock control cable assembly through the vehicle body, and then attach each clamp.

    3. Untie the string from the hood lock control cable assembly.

      B338125C04
      Table 2. Text in Illustration

      *1

      Hood Lock Control Cable

      *2

      Stopper

  2. INSTALL HOOD LOCK ASSEMBLY

    1. Apply MP grease to the sliding parts of the hood lock assembly.

    2. Connect the hood lock control cable assembly to the hood lock assembly.

    3. Install the hood lock assembly with the 3 bolts.

      8.0 N*m

      82 kgf*cm

      71 in.*lbf

    4. w/ Engine Hood Courtesy Switch:

      Connect the connector.

  3. INSTALL HOOD LOCK CONTROL CABLE COVER (w/ Cover)

    1. Attach the guide and clip to install the hood lock control cable cover.

  4. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

    1. Connect the hood lock control cable assembly to the hood lock control lever assembly.

    2. Attach the 3 claws to install the hood lock control lever assembly.

  5. INSTALL FUSE BOX OPENING COVER

    Click hereClick here

  6. INSTALL COWL SIDE TRIM BOARD RH

    Click hereClick here

  7. INSTALL FRONT DOOR SCUFF PLATE RH

    Click hereClick here

  8. INSTALL COWL TOP PANEL OUTER SUB-ASSEMBLY

    Click hereClick here

  9. INSTALL HOOD TO FRONT FENDER SEAL RH

    1. B340664

      Attach the 3 clips to install the hood to front fender seal RH.

    2. Install the clip.

  10. INSTALL HOOD TO FRONT FENDER SEAL LH

    Tip:

    Use the same procedure described for the RH side.

  11. INSTALL UPPER RADIATOR SUPPORT (w/ Cover)

    Click here

  12. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Click here

  13. INSTALL UPPER RADIATOR AIR GUIDE PLATE

    Click here

  14. INSTALL FRONT BUMPER UPPER REINFORCEMENT SUB-ASSEMBLY

    Click here

  15. INSTALL HEADLIGHT ASSEMBLY LH

    1. for Halogen Headlight:

      Click here

    2. for HID Headlight:

      Click here

  16. INSTALL HEADLIGHT ASSEMBLY RH

    Tip:

    Use the same procedure described for the LH side.

  17. INSTALL FRONT BUMPER CENTER STAY SUB-ASSEMBLY

    Click here

  18. INSTALL FRONT BUMPER COVER

    Click here

  19. INSTALL FRONT FENDER FRONT SPLASH SHIELD LH

    Click here

  20. INSTALL FRONT FENDER FRONT SPLASH SHIELD RH

    Tip:

    Use the same procedure described for the LH side.

  21. ADJUST HEADLIGHT AIMING

    1. for Halogen Headlight:

      Click here

    2. for HID Headlight:

      Click here

  22. ADJUST FOG LIGHT AIMING (w/ Fog Light)

    Click here