REAR SEAT ENTERTAINMENT SYSTEM

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tip:

  • Use the following procedure to troubleshoot the rear seat entertainment system.

  • *: Use the intelligent tester.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

    Result

    Result

    NEXT
    NEXT

  2. INSPECT BATTERY VOLTAGE

    1. Measure the battery voltage with the engine switch off.

      Standard voltage

      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

      Result

      Result

      NEXT
    NEXT

  3. CHECK FOR DTC*

    1. Refer to DTC Check / Clear.

      Click here

      Result

      Result

      Proceed to

      DTC is output

      A

      DTC is not output

      B
      Tip:

      If more information is needed, perform a recheck using the "System Check Mode" screen after checking for DTCs using the intelligent tester.

      Click here

    B

    PROBLEM SYMPTOMS TABLEClick here

    A

  4. CLEAR DTC*

    1. Clear the DTCs and finish diagnostic mode.

      Tip:

      The current DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.

      Result

      Result

      NEXT
    NEXT

  5. RECHECK FOR DTC*

    1. Recheck for DTCs.

      Result

      Result

      Proceed to

      DTC is output

      A

      DTC is not output

      B
      Tip:

      • Even if the malfunction symptom cannot be confirmed, check for DTCs. This is because the system stores past DTCs.

      • If more information is needed, perform a recheck using the "System Check Mode" screen after rechecking for DTCs using the intelligent tester.

        Click here

      • Note the DTC and inspect the area the code indicates.

    B

    PROBLEM SYMPTOMS TABLEClick here

    A

  6. DIAGNOSTIC TROUBLE CODE CHART

    1. Find the output code in the diagnostic trouble code chart.

      Click here

      Result

      Result

      NEXT
    NEXT

    CHECK CIRCUITClick here

  7. PROBLEM SYMPTOMS TABLE

    1. Refer to Problem Symptoms Table.

      Click here

      Result

      Result

      Proceed to

      Fault is not listed in problem symptoms table

      A

      Fault is listed in problem symptoms table

      B
      Tip:

      If the symptom does not recur and no DTC is output, perform the symptom simulation method.

      Click hereClick here

    B

    CHECK CIRCUITClick here

    A

  8. CHECK ECU TERMINAL BASED ON MALFUNCTION SYMPTOM

    1. Refer to Terminals of ECU.

      Click here

      Result

      Result

      NEXT
    NEXT

  9. CHECK CIRCUIT

    1. Adjust, repair or replace parts as necessary.

      Result

      Result

      NEXT
    NEXT

  10. RECHECK FOR DIAGNOSTIC TROUBLE CODE*

    Tip:

    After clearing the DTCs, recheck for DTCs.

    Result

    Result

    NEXT
    NEXT

  11. PERFORM CONFIRMATION TEST

    Result

    Result

    NEXT
    NEXT

    END