POWER WINDOW REGULATOR MOTOR INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE

  1. INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY

    1. Apply MP grease to the sliding parts of the front door window regulator assembly.

    2. B372502E01

      Install the front door window regulator assembly with the 6 bolts.

      Tip:

      Tighten the bolts in the order shown in the illustration.

      8.0 N*m

      82 kgf*cm

      71 in.*lbf

    3. Connect the connector.

  2. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

    Click hereClick here

  3. INSTALL FRONT DOOR SERVICE HOLE COVER

    Click hereClick here

  4. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP ASSEMBLY

    Click hereClick here

  5. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click hereClick here

  6. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH (w/o Mirror Heater)

    Click hereClick here

  7. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH (w/ Mirror Heater)

    Click hereClick here

  8. INSTALL FRONT DOOR TRIM COVER

    Click hereClick here

  9. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

    Click hereClick here

  10. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

    Click hereClick here

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick here

  12. INSPECT POWER WINDOW OPERATION

    Click here