ДАТЧИК ПОЛОЖЕНИЯ КОЛЕНЧАТОГО ВАЛА СНЯТИЕ


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  2. REMOVE DRIVE BELT


    1. A01DZJYE01

      С помощью шестигранника, указанного на рисунке стрелкой, сдвиньте шкив натяжителя вниз, уменьшив тем самым натяжение приводного ремня. Затем снимите приводной ремень.

      Note

      При снятии приводного ремня не следует использовать болт натяжного шкива.

      Tech Tips

      После снятия приводного ремня переместите натяжитель вверх, насколько это возможно.

  3. REMOVE COOLER COMPRESSOR ASSEMBLY


    1. A01E33NE02

      Remove the 2 bolts and disconnect the suction hose from the engine.

    2. A01DXCDE03

      Disconnect the cooler compressor connector.

    3. Remove the 4 bolts and disconnect the compressor from the engine.

    4. Support the cooler compressor securely.

  4. REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET


    1. A01DUZFE02

      Remove the 5 bolts and No. 1 compressor mounting bracket.

  5. REMOVE CRANKSHAFT POSITION SENSOR


    1. A01DXF5E04

      Disconnect the sensor connector.

    2. Disconnect the connector from the connector bracket.

    3. Detach the harness clamp.

    4. Remove the bolt and sensor.