AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

DTC Code DTC Name
Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION

The stereo jack adapter assembly sends an external device sound signal to the radio receiver assembly through this circuit.

The sound signal that has been sent is amplified by the radio receiver assembly, and then is sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio receiver assembly or speakers.

WIRING DIAGRAM

E179134E08

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - NO. 1 STEREO JACK ADAPTER)

    1. Disconnect the H114 radio receiver connector.

    2. Disconnect the H104 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      H114-28 (VAL+) - H104-6 (ALO)

      Always

      Below 1 Ω

      H114-26 (VAR+) - H104-5 (ARO)

      H114-27 (VA-) - H104-7 (ASGN)

      H114-11 (AGND) - H104-9 (AGND)

      H114-25 (ADPG) - H104-8 (AUXO)

      H114-28 (VAL+) - Body ground

      Always

      10 kΩ or higher

      H114-26 (VAR+) - Body ground

      H114-27 (VA-) - Body ground

      H114-25 (ADPG) - Body ground

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    (Click here)

    REPAIR OR REPLACE HARNESS OR CONNECTOR