FRONT DRIVE SHAFT ASSEMBLY(for 1ZR-FAE, 2ZR-FAE) INSPECTION

PROCEDURE

  1. INSPECT FRONT DRIVE SHAFT

    1. C207913

      Check that there is no severe play in the radial direction of the outboard joint.

    2. Check that the inboard joint slides smoothly in the thrust direction.

    3. Check that there is no severe play in the radial direction of the inboard joint.

    4. Check the 2 boots for damage.

    5. C127699E18

      Check that the 2 boots are not stretched or contracted when the drive shaft is at the standard length.

      Length (A) (for LH Side)

      Engine Type

      Transaxle Type

      Specified Condition

      1ZR-FAE

      Manual transaxle

      589.25 mm (1.93 ft.)

      2ZR-FAE

      Continuously variable transaxle

      Manual transaxle

      590.4 mm (1.94 ft.)

      If the boots are stretched or contracted, correct them.

      Length (A) (for RH Side)

      Engine Type

      Transaxle Type

      Specified Condition

      1ZR-FAE

      Manual transaxle

      875.25 mm (2.87 ft.)

      2ZR-FAE

      Continuously variable transaxle

      Manual transaxle

      869.3 mm (2.85 ft.)

      If the boots are stretched or contracted, correct them.