BATTERY BLOWER REMOVAL

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY RH

    Click here

  2. REMOVE FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure as for the LH side Click here.

  3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side Click here.

  4. REMOVE REAR DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure as for the LH side Click here.

  5. REMOVE LAP BELT OUTER ANCHOR COVER (for RH Side)

    Click here

  6. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

    Click here

  7. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

    Tech Tips

    Use the same procedure as for the LH side Click here.

  8. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH

    Tech Tips

    Use the same procedure as for the LH side Click here.

  9. REMOVE CENTER PILLAR LOWER GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side Click here.

  10. REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY (for RHD)

    Click here

  11. REMOVE BATTERY COOLING BLOWER ASSEMBLY

    Note


    • Be sure not to touch the fan part of the battery cooling blower assembly.

    • Do not lift the battery cooling blower assembly using the wire harness.


    1. A0059XX

      Disconnect the 2 clips and remove the No.1 rear heater register bezel.

    2. Turn over the front floor carpet.

    3. A005F3F

      Remove the 3 clips and No. 1 hybrid battery intake duct.

    4. A005C27

      Disconnect the connector.

    5. Remove the 2 bolts.

    6. A005CCG

      Remove the 3 nuts and battery cooling blower assembly from the battery cooling blower bracket.

  12. REMOVE NO. 2 HYBRID BATTERY INTAKE DUCT

    Tech Tips

    Perform this procedure only when replacement of the No. 2 hybrid battery intake duct is necessary.


    1. Remove the HV battery Click here.

    2. A005DNX

      Remove the 2 clips and No. 2 hybrid battery intake duct.