STARTER (for 1.0 kW Type) INSTALLATION


  1. INSTALL STARTER ASSEMBLY


    1. A01E2ARE01

      Install the starter with the 2 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    2. Install the starter wire to terminal 30 with the nut.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    3. Connect the terminal cap.

    4. Connect the starter connector.

  2. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

    A01DVK3E01

    1. Install the clutch release cylinder with the 2 bolts.

      Torque:
      12 N*m  { 120 kgf*cm, 9 ft.*lbf }

  3. INSTALL FRONT FENDER SEAL


    1. Install the fender seal with the 5 clips.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.