AIRBAG CUT-OFF SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the front passenger side of RHD and LHD vehicles.

  • The procedures listed below are for the front passenger side of LHD vehicles.

PROCEDURE

  1. REMOVE DECK BOARD ASSEMBLY

    Click here

  2. REMOVE BATTERY SERVICE COVER

    Click here

  3. PRECAUTION

    Note:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notice before proceeding with work.

    Click hereClick hereClick hereClick here

  4. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick here

  5. REMOVE AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY

    1. B339280C01

      *1

      Protective Tape

      Put protective tape around the airbag cut off switch cylinder sub-assembly.

    2. Using a screwdriver, detach the 2 claws.

      Tip:

      Tape the screwdriver tip before use.

    3. Disconnect the connector to remove the airbag cut off switch cylinder sub-assembly.