SEAT POSITION SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL SEAT POSITION AIRBAG SENSOR


    1. B006DRTC01
      B006AHR Positioning Pin
      B006EC9 Positioning Hole

      Align the positioning pin of the seat position airbag sensor and the positioning hole of the bracket, insert a washer in between the parts and set the parts into place.

    2. B006EZ4

      Using a T30 "TORX" socket wrench, install a new "TORX" bolt.

      Torque:
      8.0 N・m  { 82 kgf・cm }

      Note

      Do not reuse the "TORX" bolt.

    3. B006FMMC01
      B006DHE Install in this Direction

      Install the seat slide position sensor protector to the bracket.

    4. B0069X8

      Set the seat position airbag sensor together with the seat slide position sensor protector as shown in the illustration.

      Note

      Do not subject the seat position airbag sensor to any strong impact (such as dropping).

    5. B006FCYC01
      *a Check Location

      Check that the bracket protrusion is in the positioning hole of the front seat assembly LH and temporarily install a new "TORX" bolt and washer.

    6. Using a T30 "TORX" socket wrench, tighten the "TORX" bolt.

      Torque:
      8.0 N・m  { 82 kgf・cm }
    7. B006DK2C01
      *a Check Location

      Check that the bracket protrusion is in the positioning hole of the front seat assembly LH again.

    8. B006AVMC09
      *1 Seat Position Airbag Sensor
      *a 0.6 to 2 mm (0.024 to 0.079 in.)
      *b Seat Rail
      *c Adjustment Support
      B006GBM Feeler Gauge

      Using a feeler gauge, measure the clearance between the seat position airbag sensor and seat rail.

      Standard
      0.6 to 2.0 mm (0.024 to 0.079 in.)

      Note


      • Do not reuse parts if dropped or subjected to any strong impact during operation.

      • Check that a 1.3 mm (0.052 in.)clearance is maintained between the seat position airbag sensor and seat rail.

    9. If the result is not as specified, loosen the installation "TORX" bolt of the seat position airbag sensor and adjust the clearance.

      Tech Tips

      With the adjustment support as an axis, adjust the clearance by moving the seat position airbag sensor up or down.

    10. B006D7K

      Connect the connector.

    11. Check that there is no looseness in the installed seat position airbag sensor.

  2. INSTALL FRONT SEAT ASSEMBLY LH

    Click here

  3. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  4. CHECK SRS WARNING LIGHT

    Click here