STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE INSTRUMENT SIDE PANEL LH (for LHD)

    Click here

  2. REMOVE INSTRUMENT SIDE PANEL RH (for RHD)

    Click here

  3. REMOVE LOWER NO. 1 INSTRUMENT PANEL PAD SUB-ASSEMBLY

    Click here

  4. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY (STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY)


    1. for LHD:


      1. B006FJMC01
        *a Protective Tape
        B006BJ7 Insert Screwdriver Here
        B006DHE Remove in this Direction

        Insert a screwdriver at the position shown in the illustration and detach the claw and remove the integration control and panel assembly (stop and start system cancel switch).

        Tech Tips

        Tape the screwdriver tip before use.

    2. for RHD:


      1. B006BBHC01
        *a Protective Tape
        B006BJ7 Insert Screwdriver Here
        B006DHE Remove in this Direction

        Insert a screwdriver at the position shown in the illustration and detach the claw and remove the integration control and panel assembly (stop and start system cancel switch).

        Tech Tips

        Tape the screwdriver tip before use.