TELEVISION CAMERA(for Front) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front television camera assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Front bumper assembly (Including removal and installation)

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

 Parking support brake system

Click here

Front television camera assembly (Including removal and installation) Front television camera view adjustment Panoramic view monitor system

Click here

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY


    1. except Sport Package:

      Click here

    2. for Sport Package:

      Click here

  2. REMOVE FRONT TELEVISION CAMERA ASSEMBLY


    1. except Sport Package:


      1. B006C6V

        Disconnect the connector and detach the clamp.

      2. B006EA7

        Remove the 2 screws.

      3. B006GN5C01
        B006DHE Remove in this Direction

        Detach the guide and remove the front television camera assembly.

    2. for Sport Package:


      1. B006G1I

        Disconnect the connector and detach the clamp.

      2. B006CVJ

        Remove the 2 screws.

      3. B0069V1C01
        B006DHE Remove in this Direction

        Detach the guide and remove the front television camera assembly.