ECM REMOVAL

PROCEDURE

1. PERFORM REGISTRATION

   Click here

2. PRECAUTION

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click hereClick here

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click hereClick hereClick here

4. REMOVE NO. 1 ENGINE COVER

   Click hereClick hereClick here

5. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

   Click here

6. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

   Click here

8. SEPARATE NO. 1 AIR CLEANER INLET

   1. 

      Remove the bolt and separate the No. 1 air cleaner inlet.

      Note:

      Move the No. 1 air cleaner inlet to ensure enough space for the removal and installation of the ECM installation bolt.

9. REMOVE ECM

   1. 

      	Push
      	Raise

      Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.

      Note:

      After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.

   2. 

      Remove the 2 bolts and disengage the guide to remove the ECM.

      Note:

      If the ECM has been struck or dropped, replace it.

   3. 

      *1	No. 1 ECM Bracket
      *2	No. 2 ECM Bracket

      Remove the 2 screws and No. 1 ECM bracket from the ECM.

   4. Remove the 2 screws and No. 2 ECM bracket from the ECM.