TELEPHONE ANTENNA REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during roof antenna assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane Departure Alert System (w/ Steering Control)

Click here

Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System

Click here

Panoramic View Monitor System

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

B0084SX

PROCEDURE


  1. REMOVE ROOF HEADLINING ASSEMBLY

    Click here

  2. REMOVE ROOF ANTENNA ASSEMBLY WITH COVER


    1. B00886H

      Disconnect the connector.

    2. B00849U

      Remove the bolt.

    3. B008419C02
      B00847Z Remove in this Direction

      Pull the washer and holder as shown in the illustration and remove the roof antenna assembly with cover.

  3. REMOVE ROOF ANTENNA ASSEMBLY


    1. B0086OAC02
      B00847Z Remove in this Direction (1)
      B008776 Remove in this Direction (2)

      Pull the roof antenna assembly in the direction indicated by the arrow (1) shown in the illustration to disengage the 3 claws and 2 guides.

    2. Pull the roof antenna assembly in the direction indicated by the arrow (2) shown in the illustration to disengage the guide and remove the roof antenna assembly.

    3. When reusing the roof antenna assembly:


      1. B0088XB

        Remove the seal.