STEERING COLUMN ASSEMBLY REASSEMBLY

CAUTION / NOTICE / HINT

Note


  • Do not drop the power steering ECU assembly, strike it with tools or subject it to impacts.

  • If the power steering ECU assembly is subjected to an impact, replace it with a new one.

  • Do not pull the wire harness.

  • Do not allow any moisture to come into contact with the power steering ECU assembly.

  • Do not loosen any bolts not mentioned in the procedure.

  • Do not allow any foreign matter to contaminate the power steering ECU assembly.

PROCEDURE


  1. INSTALL ELECTRIC POWER STEERING MOTOR SHAFT DAMPER (for LHD)

    Click here

  2. INSTALL POWER STEERING ECU ASSEMBLY (for LHD)

    Click here

  3. INSTALL ELECTRIC POWER STEERING MOTOR SHAFT DAMPER (for RHD)

    Click here

  4. INSTALL POWER STEERING ECU ASSEMBLY (for RHD)

    Click here

  5. INSTALL STEERING LOCK ACTUATOR ASSEMBLY (w/ Entry and Start System)

    Tech Tips

    When replacing the steering lock actuator assembly, refer to the Service Bulletin.


    1. A001Y20

      Install the steering lock actuator assembly with the tapered-head bolt.

    2. Tighten the tapered-head bolt until the bolt head breaks off.

  6. INSTALL KEY INTERLOCK SOLENOID (w/o Entry and Start System)


    1. for CVT:


      1. A001TR5

        Install the key interlock solenoid to the upper steering column bracket assembly with the screw.

  7. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (w/o Entry and Start System)


    1. A001VDO

      Install the ignition or starter switch assembly with the 2 screws.

  8. INSTALL UN-LOCK WARNING SWITCH ASSEMBLY (w/o Entry and Start System)


    1. A001VN2

      Engage the 2 claws to install the un-lock warning switch assembly to the upper steering column bracket assembly.

  9. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)


    1. Make sure that the ignition switch lock cylinder assembly is in the ACC position.

    2. Install the ignition switch lock cylinder assembly.

  10. INSPECT STEERING LOCK OPERATION (w/o Entry and Start System)


    1. A001U4V

      Check that the steering lock mechanism is activated when the key is removed.

    2. A001VC2

      Check that the steering lock mechanism is deactivated when the key is inserted and turned to the ACC position.

      If there is any abnormality, replace the ignition switch lock cylinder assembly.

  11. INSTALL UPPER STEERING COLUMN BRACKET WITH SWITCH ASSEMBLY (w/o Entry and Start System)


    1. A001TYG

      Install the upper steering column bracket with switch assembly with the tapered-head bolt.

    2. Tighten the tapered-head bolt until the bolt head breaks off.

  12. INSTALL TRANSPONDER KEY COIL (w/o Entry and Start System)

    Click here