LIGHTING SYSTEM, Diagnostic DTC:B2439, B243A

DTC Code DTC Name
B2439 Headlamp LH Circuit
B243A Headlamp RH Circuit

DESCRIPTION

This DTC is output when the headlight light control ECU sub-assembly receives an abnormal signal from the headlight unit.

The headlight light control ECU sub-assembly LH outputs DTC B2439 and B243A

DTC No. Detection Item DTC Detection Condition Trouble Area
B2439 Headlamp LH Circuit Headlight light control ECU sub-assembly LH light source malfunction
  • Headlight light control ECU sub-assembly LH

  • Headlight unit LH

  • Headlight unit Assembly LH

B243A Headlamp RH Circuit Headlight light control ECU sub-assembly RH light source malfunction
  • Headlight light control ECU sub-assembly RH

  • Headlight unit RH

  • Headlight unit Assembly RH

WIRING DIAGRAM

A01XNSWE01
A01XNWBE01

CAUTION / NOTICE / HINT

Note

After the headlight light control ECU sub-assembly LH is replaced, vehicle information registration and initialization are necessary.

Click here

PROCEDURE


  1. CLEAR DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > HL AutoLeveling > Clear DTCs
      Result
      Proceed to
      NEXT

    NEXT
  2. CHECK FOR DTC


    1. Turn the engine switch on (IG).

    2. Inspect the light using the dimmer switch.

    3. Check for DTCs.

      Click here


      Body Electrical > HL AutoLeveling > Trouble Codes
      Result
      Proceed to
      DTCs B2439 and B243A are not output
      DTC B2439 is output
      DTC B243A is output

    DTCs B2439 and B243A are not output
    DTC B243A is output
    DTC B2439 is output
  3. CHECK VEHICLE CONDITION

    Result
    Proceed to
    for LED Headlight Type
    for Halogen Headlight and LED Headlight Type

    for Halogen Headlight and LED Headlight Type
    for LED Headlight Type
  4. INSPECT HEADLIGHT UNIT LH


    1. A01XOWQE02

      Remove the headlight unit LH.

      Click here

    2. Remove the headlight unit assembly LH from the headlight unit LH.

      Click here

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A-1 - E-8 Always Below 1 Ω
      A-2 - B-1 Always Below 1 Ω
      B-2 - C-1 Always Below 1 Ω
      C-2 - E-7 Always Below 1 Ω
      D-1 - F-4 Always Below 1 Ω
      D-2 - F-3 Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    NG
    OK
  5. REPLACE HEADLIGHT UNIT ASSEMBLY LH


    1. Temporarily replace the headlight unit assembly LH with a new or normally functioning one.

      Click here

      Result
      Proceed to
      NEXT

    NEXT
  6. CLEAR DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > HL AutoLeveling > Clear DTCs
      Result
      Proceed to
      NEXT

    NEXT
  7. CHECK FOR DTC


    1. Turn the engine switch on (IG).

    2. Inspect the light using the dimmer switch.

    3. Check for DTCs.

      Click here


      Body Electrical > HL AutoLeveling > Trouble Codes
      Result
      Proceed to
      DTC B2439 output does not occur
      DTC B2439 output occurs

    DTC B2439 output does not occur
    DTC B2439 output occurs
  8. INSPECT HEADLIGHT UNIT LH


    1. Remove the headlight unit LH.

      Click here

    2. A01XOYAE02

      Remove the headlight unit assembly LH from the headlight unit LH.

      Click here

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A-1 - B-4 Always Below 1 Ω
      A-2 - B-5 Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    NG
    OK
  9. REPLACE HEADLIGHT UNIT ASSEMBLY LH


    1. Temporarily replace the headlight unit assembly LH with a new or normally functioning one.

      Click here

      Result
      Proceed to
      NEXT

    NEXT
  10. CLEAR DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > HL AutoLeveling > Clear DTCs
      Result
      Proceed to
      NEXT

    NEXT
  11. CHECK FOR DTC


    1. Turn the engine switch on (IG).

    2. Inspect the light using the dimmer switch.

    3. Check for DTCs.

      Click here


      Body Electrical > HL AutoLeveling > Trouble Codes
      Result
      Proceed to
      DTC B2439 output does not occur
      DTC B2439 output occurs

    DTC B2439 output does not occur
    DTC B2439 output occurs
  12. CHECK VEHICLE CONDITION

    Result
    Proceed to
    for LED Headlight Type
    for Halogen Headlight and LED Headlight Type

    for Halogen Headlight and LED Headlight Type
    for LED Headlight Type
  13. INSPECT HEADLIGHT UNIT RH


    1. A01XOWQC01

      Remove the headlight unit RH.

      Click here

    2. Remove the headlight unit assembly RH from the headlight unit RH.

      Click here

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A-1 - E-8 Always Below 1 Ω
      A-2 - B-1 Always Below 1 Ω
      B-2 - C-1 Always Below 1 Ω
      C-2 - E-7 Always Below 1 Ω
      D-1 - F-4 Always Below 1 Ω
      D-2 - F-3 Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    NG
    OK
  14. REPLACE HEADLIGHT UNIT ASSEMBLY RH

    Result
    Proceed to
    NEXT

    NEXT
  15. CLEAR DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > HL AutoLeveling > Clear DTCs
      Result
      Proceed to
      NEXT

    NEXT
  16. CHECK FOR DTC


    1. Turn the engine switch on (IG).

    2. Inspect the light using the dimmer switch.

    3. Check for DTCs.

      Click here


      Body Electrical > HL AutoLeveling > Trouble Codes
      Result
      Proceed to
      DTC B243A output does not occur
      DTC B243A output occurs

    DTC B243A output does not occur
    DTC B243A output occurs
  17. INSPECT HEADLIGHT UNIT RH


    1. A01XOYAE03

      Remove the headlight unit RH.

      Click here

    2. Remove the headlight unit assembly RH from the headlight unit RH.

      Click here

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A-1 - B-4 Always Below 1 Ω
      A-2 - B-5 Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    NG
    OK
  18. REPLACE HEADLIGHT UNIT ASSEMBLY RH


    1. Temporarily replace the headlight unit assembly RH with a new or normally functioning one.

      Click here

      Result
      Proceed to
      NEXT

    NEXT
  19. CLEAR DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > HL AutoLeveling > Clear DTCs
      Result
      Proceed to
      NEXT

    NEXT
  20. CHECK FOR DTC


    1. Check for DTCs.

      Click here


      Body Electrical > HL AutoLeveling > Trouble Codes
      Result
      Proceed to
      DTC B2439 output does not occur
      DTC B2439 output occurs

    DTC B2439 output does not occur
    DTC B2439 output occurs