CAMSHAFT POSITION SENSOR INSTALLATION

PROCEDURE

1. INSTALL NO. 1 CRANK POSITION SENSOR (w/ Stop And Start System)

   1. 

      *1

      O-ring

      Apply a light coat of engine oil to the O-ring of the No. 1 crank position sensor.

      Note:

      If reusing the No. 1 crank position sensor, be sure to inspect the O-ring.

   2. Install the No. 1 crank position sensor onto the timing chain cover sub-assembly with the bolt.

      7.0 N*m

      71 kgf*cm

      62 in.*lbf

      Note:

      • If a component has been dropped or subjected to a strong impact, replace it.

      • Make sure that the O-ring is not damaged or does not jump out of position during installation.

   3. Connect the connector to the No. 1 crank position sensor.

2. INSTALL NO. 1 CRANK POSITION SENSOR (w/o Stop And Start System)

   1. 

      *1

      O-ring

      Apply a light coat of engine oil to the O-ring of the No. 1 crank position sensor.

      Note:

      If reusing the No. 1 crank position sensor, be sure to inspect the O-ring.

   2. Install the No. 1 crank position sensor onto the cylinder head cover sub-assembly with the bolt.

      7.0 N*m

      71 kgf*cm

      62 in.*lbf

      Note:

      • If a component has been dropped or subjected to a strong impact, replace it.

      • Make sure that the O-ring is not damaged or does not jump out of position during installation.

   3. Connect the connector of the No. 1 crank position sensor.

3. INSTALL SENSOR BRACKET (w/o Stop And Start System)

   1. Install the sensor bracket to the cylinder head cover sub-assembly with the nut.

      8.0 N*m

      82 kgf*cm

      71 in.*lbf

4. INSPECT FOR ENGINE OIL LEAK

5. INSTALL NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

   Click hereClick here