TRANSMISSION CONTROL CABLE REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick here

  3. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

  4. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  6. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

    1. Remove the air cleaner filter element sub-assembly from the air cleaner case sub-assembly.

  7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  8. REMOVE BATTERY CLAMP SUB-ASSEMBLY

    Click here

  9. REMOVE BATTERY

  10. REMOVE BATTERY TRAY

  11. DISCONNECT RADIATOR HOSE SUB-ASSEMBLY

    Click here

  12. REMOVE FRONT BATTERY BRACKET

    Click here

  13. REMOVE BATTERY BRACKET REINFORCEMENT

    Click here

  14. REMOVE FRONT FLOOR COVER

    Click here

  15. REMOVE NO. 2 ENGINE UNDER COVER

    Click hereClick here

  16. REMOVE REAR CONSOLE BOX ASSEMBLY

    Click here

  17. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

    1. Move the shift lever to N.

    2. C328346C01
      V113147

      Disconnect in this Direction

      Disconnect the end of the transmission control cable assembly from the shift lever assembly.

    3. C328347C01

      *1

      Stopper

      *2

      Nut
      V113147

      Turn in this Direction
      V113148

      Pull out in this Direction

      Pull out the stopper of the transmission control cable assembly.

    4. Turn the nut of the transmission control cable assembly counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable assembly from the shift lever assembly.

      Note:

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable assembly will not be reusable.

  18. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

    1. C296239

      Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.

    2. Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.

    3. C296306

      Remove the nut and disconnect the transmission control cable assembly from the transmission control cable support.

    4. C316613

      Remove the bolt and disconnect the transmission control cable assembly from the rear engine mounting insulator.

    5. C296270

      Remove the 2 bolts and transmission control cable assembly.