LIGHTING SYSTEM OPERATION CHECK

  1. INSPECT ILLUMINATED ENTRY SYSTEM OPERATION

    • *: When the lights are on, if the key leaves all detection areas around the doors, after approximately 3 seconds, the lights fade out.

    Note:

    Perform this inspection with the customizable parameters set to the initial settings.

    Tip:

    The illuminated entry system illuminates the lights below.

    • Engine switch illumination

    • Map light

    • No. 1 room light

    • No. 2 room light

    • Side step light

    • Interior foot lights

    • Inside handle illumination

    1. The operation and conditions of this system are described below.

      Operation

      Condition

      Lights fade in and illuminate constantly

      Any door is opened when all the doors are closed.

      Lights illuminate for 15 seconds, and then fade out

      When any of the following conditions is met:

      • The key is brought within any vehicle exterior detection area when the engine switch is off and all the doors are closed.*

      • Any door is unlocked when the engine switch is off and all the doors are closed and locked.

      • The engine switch is turned from on (ACC) to off when all doors are closed.

      • All the doors are closed when one or more doors are open and the engine switch is off.

      Lights fade out immediately

      When either of the following conditions is met:

      • The engine switch is turned from off to on (ACC) when all the doors are closed.

      • All the doors are locked when the engine switch is off, all the doors are closed and any door is unlocked.

      Battery saving

      The doors remain in the same condition for 20 minutes and the key is outside the vehicle exterior detection area.

  2. INSPECT CENTER CONSOLE SPOT LIGHT CONTROL OPERATION

    Note:

    Perform this inspection with the customizable parameters set to the initial settings.

    1. The operation and conditions of this function are described below.

      Operation

      Condition

      Light fades in

      When either of the following conditions is met, the center console spot light fades in.

      • Engine switch on (ACC)

      • Engine switch on (IG)

      Light fades out

      Engine switch off

  3. CHECK BATTERY SAVING CONTROL SYSTEM OPERATION

    1. The battery saving control (interior light auto cut function) illuminates the lights and parts below.

      • Engine switch illumination

      • Map light

      • No. 1 room light

      • No. 2 room light

      • Side step lights

      • Interior foot lights

      • Vanity lights

      • Inside handle illumination

      • Scuff plate lights*

        *: w/ Scuff plate Light

      1. The operation and operating condition of this control are described below.

        Operation

        Condition

        Battery saving (interior light auto cut function)

        20 minutes has elapsed since the engine switch was turned off, regardless of the map light switch position and whether the doors are open or closed.