ECM INSTALLATION

INSTALL NO. 2 ECM BRACKET
1. Install the No. 2 ECM bracket with the 2 screws.
  
  Torque:
  
  4.5 N*m { 46 kgf*cm, 40 in.*lbf }
INSTALL NO. 1 ECM BRACKET
1. Install the No. 1 ECM bracket with the 2 screws.
  
  Torque:
  
  4.5 N*m { 46 kgf*cm, 40 in.*lbf }
INSTALL ECM
1. Install the ECM, connect the 2 ECM connectors and lower the 2 levers.
  Note
  
  When connecting the ECM connector, make sure that dirt, water and other foreign matter is not stuck between the ECM connector and ECM.
  
  Make sure that the 2 levers are securely lowered.
2. Attach the clamp.
3. Install the 3 bolts to the ECM.
  
  Torque:
  
  5.5 N*m { 56 kgf*cm, 49 in.*lbf }
  
  Note
  
  Do not use an ECM that has been dropped or subjected to a strong impact.
4. Return the floor carpet to its original position.
INSTALL FRONT SEAT ASSEMBLY RH
1. Connect the front seat inner belt assembly connector and install the front seat assembly.
2. Align the front seat assembly adjuster pin with the holes in the body.
3. Move the front seat assembly to the rearmost position.
  
  Note
  
  Make sure that the front seat assembly is securely locked.
4. Temporarily tighten the 2 bolts on the front side of the front seat assembly.
5. Move the front seat assembly fully forward.
  
  Note
  
  Make sure that the front seat assembly is securely locked.
6. Temporarily tighten the 2 bolts on the rear side of the front seat assembly.
7. Move the front seat assembly to the rearmost position.
  
  Note
  
  Make sure that the front seat assembly is securely locked.
8. Fully tighten the 2 bolts on the front side of the front seat assembly in the order of outer and inner side.
  
  Torque:
  
  39 N*m { 398 kgf*cm, 29 ft.*lbf }
9. Move the front seat assembly fully forward.
  
  Note
  
  Make sure that the front seat assembly is securely locked.
10. Fully tighten the 2 bolts on the rear side of the front seat assembly in the order of outer and inner side.
  
  Torque:
  
  39 N*m { 398 kgf*cm, 29 ft.*lbf }
INSTALL SEAT TRACK COVER LH
1. Attach the claw and install a new seat track cover LH with a new clip.
INSTALL FRONT DOOR SCUFF PLATE RH
1. Attach the 5 clips to install the front door scuff plate RH.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
PERFORM REGISTRATION

Click here