LUGGAGE COMPARTMENT DOOR CLOSER SWITCH REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the luggage compartment door closer switch removal/installation are shown below.

Replacement Part Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
When the luggage compartment door is opened using a mechanical key Initialize luggage closer motor assembly The power trunk lid does not operate

Click here

PROCEDURE


  1. REMOVE LUGGAGE COMPARTMENT DOOR ASSIST GRIP

    Click here

  2. REMOVE SWITCH BEZEL

    Click here

  3. REMOVE NO. 2 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

    Click here

  4. REMOVE LUGGAGE COMPARTMENT DOOR COVER

    Click here

  5. REMOVE DOOR CONTROL SWITCH


    1. B006CRNC02
      B006AHR Screw
      B006EC9 Connector

      Disconnect the connector.

    2. Remove the 2 screws.

    3. B006E29

      Detach the claw and remove the door control switch.