COMPRESSOR(for 2AR-FE) DISASSEMBLY

PROCEDURE

  1. REMOVE COOLER COMPRESSOR BRACKET

    1. Disconnect the connector.

    2. Detach the connector clamp.

    3. E271003

      Remove the screw and cooler compressor bracket.

  2. REMOVE MAGNET CLUTCH ASSEMBLY

    1. E271004C01

      *a

      Hold

      *b

      Turn

      Clamp the cooler compressor in a vise between aluminum plates.

    2. Using SST, hold the magnet clutch hub.

      09985-00270

    3. Remove the bolt, magnet clutch hub and magnet clutch washer(s).

      Tip:

      There is no set number of magnet clutch washers since they are used for adjusting.

    4. E271005

      Using a snap ring expander, remove the snap ring.

      Note:

      Do not damage the seal cover of the bearing when removing the snap ring.

    5. Detach the connector clamp and remove the magnet clutch rotor.

    6. E271006

      Using a snap ring expander, remove the snap ring and magnet clutch stator.