AIRBAG SYSTEM CHECK MODE PROCEDURE

Note:

Enter "Signal Check" from the "DTC Check" screen displayed on the intelligent tester to clear the output DTCs (both present and past).

Tip:
  • DTCs can be stored more sensitively in check mode than in normal diagnosis mode.

  • Perform the check mode inspection when a malfunction in each squib circuit is suspected even after the normal system code is output through normal diagnosis mode inspection.

  1. CHECK MODE PROCEDURE (Using an Intelligent Tester)

    1. Turn the ignition switch off.

    2. Connect the intelligent tester to the DLC3.

    3. Turn the ignition switch to ON.

    4. Turn the intelligent tester on.

    5. Enter the following menus: Body / SRS Airbag / Utility / Signal Check*.

      • *: Follow the directions on the intelligent tester screen.