SLIDE DOOR LOCK RELEASE MOTOR REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE SLIDE DOOR WINDOW GARNISH LH


    1. B007VXE

      Disengage the 4 clips and remove the slide door window garnish.

  3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. B007T23

      Using "TORX" socket wrench T25, remove the 2 screws.

    2. B007S92

      Disengage the claw and 19 clips, and remove the rear door trim board.

  4. REMOVE REAR DOOR SCUFF PLATE LH


    1. B007R3Z

      Disengage the claw and 12 clips.

    2. Disconnect the connector and remove the rear door scuff plate.

  5. REMOVE SIDE STEP REAR SUPPORT LH

    B007S5A

    1. Remove the 3 bolts and the side step rear support.

  6. REMOVE DOOR CONTROL RELAY ASSEMBLY

    B007PEY

    1. Disconnect the connectors.

    2. Remove the bolt and the door control relay.

  7. REMOVE REAR NO. 2 DOOR WIRE


    1. B007QKD

      Remove the bolt.

    2. B007VTR

      Disconnect the connector from the vehicle.

    3. B007SVI

      Remove the 4 bolts, and then disengage the 4 clips.

    4. Disconnect the connector of the door, and remove the rear No. 2 door wire.

      Note

      Do not put anything on the rear No. 2 door wire after removal.

  8. REMOVE SLIDE DOOR SERVICE HOLE COVER LH


    1. B007TI4

      Disengage the clamp.

    2. Disconnect the cable from the slide door lock remote control.

    3. Remove the slide door service hole cover.

  9. REMOVE SLIDE DOOR LOCK RELEASE MOTOR

    B007OUB

    1. Disconnect the connector and cable.

    2. Disconnect the link.

    3. Remove the 3 bolts and the slide door lock release motor.