EGR COOLER INSTALLATION

PROCEDURE


  1. INSTALL EGR WITH COOLER PIPE SUB-ASSEMBLY


    1. A005CT5

      Temporarily install a new gasket and EGR valve assembly to the EGR cooler assembly with the 2 nuts.

    2. Install a new gasket and set the EGR valve with cooler assembly in place.

    3. Using an E8 "TORX" socket wrench, install the 4 stud bolts.

      A005AN5E01
      Text in Illustration
      *a Stud Bolt A *b Stud Bolt B
      *c Stud Bolt C - -
      Torque:
      Stud Bolt A and Stud Bolt B
      9.5 N*m  { 97 kgf*cm, 84 in.*lbf }
      Stud Bolt C
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

      If a stud bolt is deformed or the threads are damaged, replace it.

    4. Temporarily install the 2 nuts (B), 2 nuts (C) and bolt.

      Tech Tips

      The type B nut and type C nut are non-reusable.

    5. Tighten the 2 nuts (A).

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

    6. Tighten the 2 nuts (B) and bolt.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

      Note

      Make sure that all installation surfaces of the EGR valve with cooler assembly are in even contact when tightening the bolt and nuts.

    7. Tighten the 2 nuts (C).

      A005A3VE02
      Text in Illustration
      *A Type A *B Type B
      *C Type C - -
      *a Nut A *b Nut B
      *c Nut C *d Bolt
      Torque:
      Type A
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }
      Type B
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }
      Type C
      26 N*m  { 265 kgf*cm, 19 ft.*lbf }
    8. A005F1I

      Connect the EGR valve assembly connector and engage the wire harness clamp.

    9. Connect the 4 water hoses to the EGR valve assembly and slide the 4 clips to secure them.

  2. INSTALL EGR PIPE ASSEMBLY

    Click here

  3. INSTALL AIR CLEANER CASE

    Click here

  4. INSTALL INLET AIR CLEANER ASSEMBLY

    Click here

  5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  6. INSTALL NO. 2 CYLINDER HEAD COVER

    Click here

  7. ADD COOLANT (for Engine)

    Click here

  8. INSPECT FOR COOLANT LEAK (for Engine)

    Click here

  9. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)

    Click here

  10. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

    Click here

  11. INSTALL COWL BODY MOUNTING REINFORCEMENT LH (for LHD)

    Click here

  12. INSTALL COWL BODY MOUNTING REINFORCEMENT RH (for RHD)

    Click here

  13. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Click here