G-BOOK SYSTEM(w/ Telematics Transceiver) PROBLEM SYMPTOMS TABLE
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Symptom |
Suspected Area |
Link |
|---|---|---|
After "Wait for a while." is displayed, it takes a long time to display the screen |
This is caused when there is a problem with the radio wave signal conditions or when the base station is busy. This is not a malfunction (convince the customer that this is not a malfunction and ask them to use the system as is). |
- |
"The lines are busy. Operate it after waiting for a while." is displayed |
Telephone calls are being restricted by the communication provider. Explain to the customer that they need to wait for a while before using the service. |
- |
"The lines are busy and it is not possible to display the desired content. Please try again (operate it again) after waiting for a while." is temporarily displayed |
This is caused when there is a problem with the radio wave signal conditions or when the base station is busy. This is not a malfunction (convince the customer that this is not a malfunction and ask them to use the system as is). |
- |
"The lines are busy and it is not possible to display the desired content. Please try again (operate it again) after waiting for a while." remains displayed |
Proceed to "Communication Access Failed" |
|
"The lines are busy and information was not able to be acquired." is displayed |
Wait for a while and perform the operation again in a different location |
- |
Proceed to "Communication Access Failed" |
||
"The lines are shut off and information was not able to be acquired." is displayed |
Proceed to "Communication Access Failed" |
|
"Information was not able to be acquired." is displayed |
Proceed to "Communication Access Failed" |
|
"Communication in preparation now. Wait for a while." is displayed |
The system is trying to detect the telematics transceiver. Wait for a while and perform the operation again. |
- |
Proceed to "Telematics Transceiver Malfunction" |
||
"No response from the communication module. G-BOOK service is not available now." is displayed |
Proceed to "Telematics Transceiver Malfunction" |
|
"Outside the telephone call area. Move to the telephone call area and use it." is displayed |
Wait for a while and perform the operation again in a different location (within the communication service area). |
- |
Proceed to "Communication Access Failed" |
||
"Because the time data is old, it is not possible to communicate. Receive GPS." is displayed |
Proceed to Problem Symptoms Table (GPS mark is not displayed) of the Navigation System (for HDD) section. |
|
If the GPS mark is displayed, wait for a while and perform the operation again in a different location. |
- |
|
If the problem symptom reoccurs, replace the display and navigation module display. |
||
"This service is not available because the microphone is not connected." is displayed |
Proceed to "Microphone Circuit between Microphone and Navigation ECU" of the Navigation System (for HDD) section. |
|
"Could not be registered to the bookmark." is displayed when registering a bookmark |
Explain to the customer that this operation is not possible in a cold environment (-20°C [-4°F] or less) and that they need to wait until the cabin temperature rises. |
- |
Proceed to Operation Check - Check Hard Disk Drive of the Navigation System (for HDD) section. |
||
"Could not be deleted." is displayed when deleting a bookmark |
Explain to the customer that this operation is not possible in a cold environment (-20°C [-4°F] or less) and that they need to wait until the cabin temperature rises. |
- |
Proceed to Operation Check - Check Hard Disk Drive of the Navigation System (for HDD) section. |
||
"Could not be renewed." is displayed when editing a bookmark |
Explain to the customer that this operation is not possible in a cold environment (-20°C [-4°F] or less) and that they need to wait until the cabin temperature rises. |
- |
Proceed to Operation Check - Check Hard Disk Drive of the Navigation System (for HDD) section. |
||
"Could not be edited." is displayed when editing a fixed phrase |
Explain to the customer that this operation is not possible in a cold environment (-20°C [-4°F] or less) and that they need to wait until the cabin temperature rises. |
- |
Proceed to Operation Check - Check Hard Disk Drive of the Navigation System (for HDD) section. |
||
"Could not be deleted." is displayed when deleting the input history |
Explain to the customer that this operation is not possible in a cold environment (-20°C [-4°F] or less) and that they need to wait until the cabin temperature rises. |
- |
Proceed to Operation Check - Check Hard Disk Drive of the Navigation System (for HDD) section. |
Symptom |
Suspected Area |
Link |
|---|---|---|
G-BOOK announcement sound is not output |
Adjust the volume by referring to the owner's manual. The G-BOOK announcement sound is not linked with the audio volume. |
- |
Symptom |
Suspected Area |
Link |
|---|---|---|
"Communication needs to be initialized. Proceed to G-BOOK.com on the Main Menu screen to initialize." is displayed |
Explain to the customer that a procedure must be performed in order to use the G-BOOK service. Ask the customer to perform the procedure by referring to the owner's manual. |
- |
"G-BOOK contract is needed. Ask a dealership how to apply for the G-BOOK service." is displayed |
Fill in the vehicle contract setting request form and contact the G-BOOK support center. |
- |
Symptom |
Suspected Area |
Link |
|---|---|---|
"Please note that this service is not available now." is displayed |
Proceed to "G-BOOK Service cannot be Used" |
|
"Contract is not completed for this service. Complete the contract before use." is displayed |
Proceed to "G-BOOK Service cannot be Used" |
|
"Emergency call service is not available because the procedure to start the service has not been performed." is displayed |
Proceed to "G-BOOK Service cannot be Used" |
Symptom |
Suspected Area |
Link |
|---|---|---|
The indicator lights on the emergency call switch panel do not come on when the engine switch is turned on (ACC) |
Check that G-BOOK contract enrollment and the procedure to start the emergency call service have been completed successfully. |
- |
The red indicator light on the emergency call switch panel comes on after the engine switch is turned on (ACC) |
The vehicle is outside the communication service area. Move the vehicle to a communication service area. |
- |
The red indicator light on the emergency call switch panel blinks after the engine switch is turned on (ACC) |
Check for DTCs |
|
Turning the engine switch on (ACC) causes a manual maintenance check to start |
Proceed to DTC B15C5 |
|
The red indicator light on the emergency call switch panel does not blink after the engine switch is turned on (ACC), but it blinks after the vehicle is driven |
Proceed to DTC B15C6 |
Symptom |
Suspected Area |
Link |
|---|---|---|
The G-BOOK center cannot be accessed even after a manual maintenance check is performed |
Check that the G-BOOK service is available. |
- |
Proceed to "Communication Access Failed" |
||
The automatic maintenance check does not complete normally |
Perform a manual maintenance check. If it does not complete normally, refer to "The G-BOOK center cannot be accessed even after a manual maintenance check is performed". |
- |
The G-BOOK center cannot be accessed by pressing the emergency call switch |
Perform a manual maintenance check. If it does not complete normally, refer to "The G-BOOK center cannot be accessed even after a manual maintenance check is performed". |
- |
Symptom |
Suspected Area |
Link |
|---|---|---|
The display and navigation module display does not show a warning message even though a warning light turns on and the multi-information display indicates a warning |
Proceed to "Warning Notification Function Malfunction" |
|
The display and navigation module display shows a warning message even though the corresponding warning light is not on and the multi-information display does not indicate a warning |
Proceed to "Warning Notification Function Malfunction" |
|
The display and navigation module display shows a warning message different from the warning light or multi-information display |
Proceed to "Warning Notification Function Malfunction" |
|
The same warning notification is repeated |
Proceed to "Warning Notification Function Malfunction" |
Symptom |
Suspected Area |
Link |
|---|---|---|
When the vehicle automatic alarm is activated, the G-BOOK center is not informed of the alarm |
Proceed to "Security History" |
|
Proceed to CAN communication system |
Symptom |
Suspected Area |
Link |
|---|---|---|
"Please note that this service is not available now." is displayed |
Proceed to "G-BOOK Service cannot be Used" |
|
"Contract is not completed for this service. Complete the contract before use." is displayed |
Proceed to "G-BOOK Service cannot be Used" |
Symptom |
Suspected Area |
Link |
|---|---|---|
When using the operator service, the other caller's voice cannot be heard |
Check if the navigation voice guidance is output normally. If not, refer to Navigation System (for HDD). |
|
Proceed to "Received Voice Signal Circuit" |
||
When using the operator service, noise occurs in the transmitted voice (caller's voice) |
Proceed to "Transmitted Voice Signal Circuit" |
|
When using the operator service, voice cannot be transmitted (the other caller cannot hear the caller's voice) |
Proceed to "Transmitted Voice Signal Circuit" |