COOLER EXPANSION VALVE INSTALLATION
PROCEDURE
INSTALL COOLER EXPANSION VALVE
Apply sufficient compressor oil to 2 new O-rings and the fitting surfaces of the cooler expansion valve.
Compressor Oil
ND-OIL 8 or equivalent
Install the 2 O-rings to the No. 1 cooler evaporator sub-assembly.
Using a 4 mm hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.
3.5 N*m
36 kgf*cm
31 in.*lbf
INSTALL COOLER CAP (w/o Cooler System)
CONNECT AIR CONDITIONER TUBE ASSEMBLY (w/ Cooler System)
CONNECT SUCTION PIPE SUB-ASSEMBLY (w/ Cooler System)
Remove the vinyl tape from the suction pipe sub-assembly.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the suction pipe sub-assembly.
Compressor Oil
ND-OIL 8 or equivalent
Install the O-ring to the suction pipe sub-assembly.
Connect the suction pipe sub-assembly.
-
Rotate the hook connector as shown in the illustration.
Insert the pipe joint into the fitting hole securely and install the bolt.
9.8 N*m
100 kgf*cm
87 in.*lbf
INSTALL OUTER COWL TOP PANEL (for 1AD-FTV, 1ND-TV)
for LHD:
for Sedan:Click here
for Hatchback, Wagon:Click here
for RHD:
for Sedan:Click here
for Hatchback, Wagon:Click here
INSTALL NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL (for 1AD-FTV, 1ND-TV)
for LHD:
for Sedan:Click here
for Hatchback, Wagon:Click here
for RHD:
for Sedan:Click here
for Hatchback, Wagon:Click here
INSTALL WATER GUARD PLATE LH (for 1AD-FTV, 1ND-TV)
for LHD:
for Sedan:Click here
for Hatchback, Wagon:Click here
for RHD:
for Sedan:Click here
for Hatchback, Wagon:Click here
INSTALL DIFFERENTIAL PRESSURE SENSOR ASSEMBLY (for 1AD-FTV)
INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for 1AD-FTV, 1ND-TV)
CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT (w/ Cooler System)
WARM UP ENGINE (w/ Cooler System)
INSPECT FOR REFRIGERANT LEAK (w/ Cooler System)