VANE PUMP (for 1GD-FTV) INSTALLATION


  1. INSTALL VANE PUMP ASSEMBLY


    1. Install the vane pump assembly with the 2 bolts.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

  2. CONNECT PRESSURE FEED TUBE ASSEMBLY


    1. Install a new gasket to the pressure feed tube assembly.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

  3. CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE


    1. Connect the No. 1 oil reservoir to pump hose to the vane pump assembly and slide the hose clip.

  4. INSTALL FAN AND GENERATOR V BELT


    1. Set the fan and generator V belt onto each part.

      Tech Tips

      When installing the fan and generator V belt, attach the fan and generator V belt to the No. 1 idler pulley sub-assembly last.

    2. While turning the V-ribbed belt tensioner assembly clockwise, remove the pin.

    3. Check that the fan and generator V belt fits properly in the ribbed grooves.

      Note

      Make sure that the fan and generator V belt is set properly on each pulley.

  5. ADD POWER STEERING FLUID

  6. BLEED POWER STEERING FLUID

    Click here

  7. INSPECT POWER STEERING FLUID LEAK