LIGHTING SYSTEM DATA LIST / ACTIVE TEST

  1. DATA LIST

    Note:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Warm up the engine.

    2. Turn the ignition switch off.

    3. Connect the GTS to the DLC3.

    4. Turn the ignition switch to ON.

    5. Turn the GTS on.

    6. Enter the following menus: Body Electrical / Combination Meter / Data List.

    7. Check the values by referring to the table below.

      Body Electrical > Combination Meter > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      Turn Signal Switch (Right)

      Turn signal switch in right turn position signal

      ON or OFF

      ON: Turn signal switch in right turn position

      OFF: Turn signal switch not in right turn position

      -

      Turn Signal Switch (Left)

      Turn signal switch in left turn position signal

      ON or OFF

      ON: Turn signal switch in left turn position

      OFF: Turn signal switch not in left turn position

      -

      Hazard Flasher Switch

      Hazard warning signal switch signal

      ON or OFF

      ON: Hazard warning signal switch on

      OFF: Hazard warning signal switch off

      -

      Turn Switch Signal (Full Turn)

      Turn signal switch in full turn position signal

      ON or OFF

      ON: Turn signal switch in full left turn or full right turn position

      OFF: Turn signal switch in neither full left turn nor full right turn position

      -