AUTOMATIC TRANSAXLE SYSTEM, Diagnostic DTC:P2716
| DTC Code | DTC Name |
|---|---|
| P2716 | Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT) |
DESCRIPTION
Refer to DTC P2714.
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
MIL |
Memory |
|---|---|---|---|---|---|
P2716 |
Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT) |
An open or short is detected in the shift solenoid valve SLT circuit for 1 second or more while driving (1-trip detection logic). |
|
Comes on |
DTC stored |
MONITOR DESCRIPTION
When an open or short in the shift solenoid valve SLT circuit is detected, the TCM interprets this as a fault. The TCM will turn on the MIL and store the DTC.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
Perform registration and/or initialization when parts related to the automatic transaxle are replaced.
PROCEDURE
INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SLT)
-
*a
Component without TCM connected
(Transmission Wire)
Remove the TCM.
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
12 (SLT+) - 7 (SLT-)
20°C (68°F)
5.0 to 5.6 Ω
12 (SLT+) - Body ground
Always
10 kΩ or higher
7 (SLT-) - Body ground
Always
10 kΩ or higher
12 (SLT+) - All other terminals except 7 (SLT-)
Always
10 kΩ or higher
7 (SLT-) - All other terminals except 12 (SLT+)
Always
10 kΩ or higher
Result
Proceed to
OK
NG
-
INSPECT SHIFT SOLENOID VALVE SLT
-
*1
Shift Solenoid Valve SLT
Remove shift solenoid valve SLT.
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
5.0 to 5.6 Ω
Apply 12 V battery voltage to the shift solenoid valve and check that the valve moves and makes an operating noise.
OK
Measurement Condition
Specified Condition
Battery positive (+) with a 21 W bulb → Terminal 1
Battery negative (-) → Terminal 2
Valve moves and makes an operating noise
Result
Proceed to
OK
NG
-