OUTER REAR VIEW MIRROR REASSEMBLY

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. INSTALL OUTER MIRROR RETRACTOR LH

    1. Install the support with the 4 screws.

    2. Pass a new harness sub-assembly through the frame sub-assembly.

    3. Connect the connector.

    4. B342360

      Temporarily install a new frame sub-assembly as shown in the illustration.

    5. Install the new frame sub-assembly with the 2 screws.

      2.0 N*m

      20 kgf*cm

      18 in.*lbf

    6. Using a T25 "TORX" socket wrench, install 3 new screws.

      3.3 N*m

      34 kgf*cm

      29 in.*lbf

    7. Install the gasket sub-assembly to the outer rear view mirror assembly LH.

    8. B342385C02

      *1

      Tape

      Wrap new tape as shown in the illustration.

      Area

      Measurement

      A

      50 mm

  2. INSTALL LOWER OUTER MIRROR COVER LH

    1. B340669

      Attach the 5 claws to install the lower outer mirror cover LH.

    2. Attach the 5 guides and install the gasket.

  3. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH

    Click here

  4. INSTALL OUTER MIRROR COVER LH

    Click here

  5. INSTALL OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH

    Click here