PARK / NEUTRAL POSITION SWITCH INSTALLATION

PROCEDURE

  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    1. Install the park/neutral position switch assembly to the continuously variable transaxle assembly.

    2. C169001

      Temporarily install the 2 bolts.

    3. C169002

      Install a new lock plate and the lock nut to the park/neutral position switch assembly.

      6.9 N*m

      70 kgf*cm

      61 in.*lbf

    4. Temporarily install the control shaft lever.

    5. C169003E02

      Turn the lever clockwise until it stops, and then turn it counterclockwise 2 notches.

    6. Remove the control shaft lever.

    7. C169004C01

      *a

      Neutral Basic Line

      *b

      Protrusion

      Align the protrusion with the neutral basic line.

    8. Hold the switch in that position and tighten the 2 bolts.

      5.4 N*m

      55 kgf*cm

      48 in.*lbf

    9. C169005

      Using a screwdriver, bend the tabs of the lock plate.

    10. Install the control shaft lever with the washer and nut.

      13 N*m

      133 kgf*cm

      10 ft.*lbf

    11. Connect the park/neutral position switch connector.

  2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

    1. Connect the transmission control cable assembly to the control shaft lever with the nut.

      12 N*m

      122 kgf*cm

      9 ft.*lbf

  3. INSPECT SHIFT LEVER POSITION

    Click here

  4. ADJUST SHIFT LEVER POSITION

    Click here

  5. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    Click here

  6. INSTALL NO. 1 ENGINE UNDER COVER

    1. for 3ZR-FE:

      Click here

    2. for 3ZR-FAE:

      Click hereClick hereClick here