FUEL INJECTOR(w/o Glow Plug Controller) INSPECTION

PROCEDURE

  1. INSPECT INJECTOR ASSEMBLY

    1. A211265C01

      *a

      Component without harness connected (Injector Assembly)

      Check the resistance.

      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection

        Condition

        Specified Condition

        1 - 2

        20°C (68°F)

        150 to 210 kΩ

        If the result is not as specified, replace the injector assembly.