BLACK OUT TAPE(for Rear Door) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. REPAIR INSTRUCTION

   Click here

2. INSTALL REAR INNER BLACK OUT TAPE

   
   

   1. Refer to the illustration to position a new rear inner black out tape.

      

      *A	LH Side	*B	RH Side
      *a	Edge of Curved Surface	*b	Straight
      *c	Triangle	-	-

      Standard Measurement
      Area Measurement Area Measurement A 7.0 mm (0.276 in.) B 4.0 mm (0.157 in.) C 1.5 mm (0.0591 in.) D 1.0 mm (0.0394 in.)

   2. Remove the release paper and apply the rear inner black out tape.

3. INSTALL REAR DOOR OUTSIDE STRIPE

   
   

   1. Refer to the illustration to position a new rear door outside stripe.

      

      *A	LH Side	*B	RH Side
      *a	Edge of Curved Surface	*b	Straight
      *c	Triangle	-	-

      Standard Measurement
      Area Measurement Area Measurement A 5.0 mm (0.197 in.) B 10.0 mm (0.394 in.) C 1.5 mm (0.0591 in.) D 1.0 mm (0.0394 in.)

   2. Remove the release paper and apply the rear door outside stripe.

4. INSTALL CURTAIN HOOK (w/ Rear Door Sunshade)

   Click here

5. INSTALL REAR DOOR LOWER OUTSIDE STRIPE

   
   

   1. Refer to the illustration to position a new rear door lower outside stripe.

      

      *A	LH Side	*B	RH Side
      *a	Straight	*b	Triangle

      Standard Measurement
      Area Measurement Area Measurement A 3.0 mm (0.118 in.) B 10.0 mm (0.394 in.) C 1.2 mm (0.0472 in.) D 3.2 mm (0.126 in.)

   2. Remove the release paper and apply the rear door lower outside stripe.

6. INSTALL REAR DOOR FRAME GARNISH

   Click here

7. INSTALL REAR DOOR FRONT BELT SEAL

   Click here

8. CONNECT REAR DOOR WEATHERSTRIP

   Click here

9. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

   Click here

10. INSTALL REAR DOOR REAR GUIDE SEAL

    Click here

11. CONNECT REAR DOOR WEATHERSTRIP

    Click here

12. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

    Click here

13. INSTALL REAR DOOR GLASS RUN

    Click here

14. INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

15. INSTALL REAR DOOR NO. 2 TRIM BRACKET

    Click here

16. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

17. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

18. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

19. INSTALL REAR DOOR ARMREST COVER

    Click here

20. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

    Click here

21. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

22. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

23. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

24. INSPECT POWER WINDOW OPERATION

    Click here