TRANSMISSION CONTROL CABLE(for TMMT Made) INSTALLATION

PROCEDURE

  1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

    1. Pass the transmission control cable assembly into the vehicle and install the transmission control cable assembly to the vehicle body with the 2 nuts.

      5.0 N*m

      51 kgf*cm

      44 in.*lbf

    2. Connect the transmission control cable assembly to the rear engine mounting insulator with the bolt.

      5.0 N*m

      51 kgf*cm

      44 in.*lbf

    3. Connect the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.

    4. C310228C01

      *a

      P Position

      *b

      N Position

      Turn the control shaft lever clockwise until it stops, then turn it counterclockwise 2 notches.

    5. Connect the transmission control cable assembly to the control shaft lever with the nut.

      12 N*m

      122 kgf*cm

      9 ft.*lbf

    6. Turn the nut of the transmission control cable assembly approximately 180° counterclockwise. While holding the nut in place, push in the stopper until it clicks twice.

      C151676C11

      *a

      Stopper

      *b

      Nut

      *c

      Push in

      *d

      Turn approximately 180°
      Tip:

      If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.

    7. Connect the transmission control cable assembly to the shift lever assembly. Check that the spring is positioned at (A) and push in the stopper.

      C270204C05

      *1

      Transmission Floor Shift Assembly

      -

      -

      *a

      Stopper

      *b

      Spring

      *c

      Nut

      *d

      Push in
      Note:

      • If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.

      • Make sure that the transmission control cable assembly is securely locked.

    8. C330480

      Confirm that the shift lever is in N, and then install the end of the transmission control cable assembly to the transmission floor shift assembly.

      Note:

      • Securely install the end of the transmission control cable assembly to the transmission floor shift assembly.

      • Install the end of the transmission control cable assembly so that its adjustment lock section is on the driver side.

  2. ADJUST SHIFT LEVER POSITION

    Click here

  3. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR

    1. Install the front No. 1 floor heat insulator to the vehicle body with the 3 nuts.

      5.5 N*m

      56 kgf*cm

      49 in.*lbf

  4. INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Front and Rear Catalyst)

    Click hereClick here

  5. INSTALL FRONT CENTER FLOOR BRACE SUB-ASSEMBLY

    Click here

  6. INSTALL BATTERY CARRIER ASSEMBLY

    Click hereClick here

  7. INSTALL BATTERY

    Click hereClick here

  8. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    Click hereClick here

  9. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  10. INSTALL NO. 2 CYLINDER HEAD COVER

    Click hereClick here

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick here

  12. INSTALL REAR CONSOLE BOX ASSEMBLY

    Click here

  13. INSPECT SHIFT LEVER POSITION

    Click here

  14. INSPECT FOR EXHAUST GAS LEAK