FRONT UPPER SUSPENSION ARM (for 2WD) INSPECTION


  1. INSPECT FRONT UPPER SUSPENSION ARM ASSEMBLY LH

    A01DYHRE01

    1. As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.

    2. Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the fifth turn.

      Turning torque
      0.98 to 4.5 N*m (10 to 46 kgf*cm, 9 to 40 in.*lbf) or less

    3. Check for any cracks and grease leaks on the ball joint dust cover.