ЖГУТ ЭЛЕКТРОПРОВОДКИ ТРАНСМИССИИ УСТАНОВКА

Note

When working with seal packing, perform the following:


  • Using a razor blade and gasket scraper, remove all old seal packing from the gasket surfaces.

  • Clean all components thoroughly to remove all foreign matter.

  • Clean both sealing surfaces with a non-residue solvent.

  • Apply seal packing in a continuous line approximately 2 to 3 mm (0.0787 to 0.118 in.) in diameter on the sealing surface.

  • Reassemble parts within 10 minutes of applying seal packing. Failing to do so will require the seal packing to be removed and reapplied.


  1. INSTALL TRANSMISSION WIRE

    A01E2CYE01

    1. Coat a new O-ring with ATF, and install it to the transmission wire.

    2. Install the transmission wire to the case, and install the stopper plate with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  2. CONNECT TRANSMISSION WIRE

    A01E23EE01

    1. Connect the 4 connectors to the 4 shift solenoid valves.

  3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

    A01DY2ZE01

    1. Install 3 new gaskets.

    2. A01E1QKE03

      Install the oil strainer with the 4 bolts.

      Torque:
      11 N*m  { 110 kgf*cm, 8 ft.*lbf }

      Tech Tips

      Bolt length:

      14 mm (0.55 in.) for A

      20 mm (0.79 in.) for B

      23 mm (0.91 in.) for C

  4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

    A01DYJFE02

    Tech Tips

    Remove any packing material and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.


    1. Install the 3 magnets to the locations indicated in the illustration.

    2. A01DVJP

      Apply seal packing to the oil pan as shown in the illustration.

      Seal packing
      Toyota Genuine Seal Packing 1281,
      Three Bond 1281 or equivalent
      Seal width
      2 to 3 mm (0.0787 to 0.118 in.)

    3. Install the oil pan with the 19 bolts.

      Torque:
      7.4 N*m  { 75 kgf*cm, 65 in.*lbf }

  5. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY

    A01DYZ6

    1. Coat a new O-ring with ATF, and install it to the oil filler tube.

    2. Install the oil filler tube with the 2 bolts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

    3. Install the oil dipstick.

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    Certain systems need to be initialized after disconnecting and reconnecting the cable to the negative (-) battery terminal.

  7. PERFORM INITIALIZATION


    1. Perform initialization Click here.

  8. ADD AUTOMATIC TRANSMISSION FLUID

    Fluid type
    Toyota Genuine ATF Type T-IV

  9. INSPECT AUTOMATIC TRANSMISSION FLUID


    1. Inspect the automatic transmission fluid Click here.