REAR BUMPER(w/o Rear No. 2 Seat) REMOVAL

PROCEDURE


  1. REMOVE REAR LIGHT COVER LH

    Click here

  2. REMOVE REAR LIGHT COVER RH

    Tech Tips

    Use the same procedure as for the LH side.

  3. DISCONNECT QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH


    1. B007Y27C02
      B007ZL6 Protective Tape

      Apply protective tape around the quarter outside moulding sub-assembly LH and rear bumper assembly as shown in the illustration.

    2. B007X3M

      Using a 4 mm hexagon socket wrench, remove the screw.

    3. Remove the clip.

    4. B007XLGC01
      B007Z37 Remove in this Direction (1)
      B007YXL Remove in this Direction (2)

      Pull back the edge of the rear wheel house liner LH and disengage the 4 claws by pushing the area indicated by the arrow in the illustration with a finger.

      Note


      • Do not apply excessive force when pulling back the rear wheel house liner LH.

      • To avoid damaging the claws, do not forcibly pull the quarter outside moulding sub-assembly LH.

    5. Disengage the clip to disconnect the quarter outside moulding sub-assembly LH from the rear bumper assembly.

  4. DISCONNECT QUARTER OUTSIDE MOULDING SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  5. REMOVE REAR BUMPER ASSEMBLY


    1. B007X71

      Remove the 4 screws.

    2. B007ZAL

      Remove the 6 clips.

    3. B007XUMC01
      B007Z37 Remove in this Direction

      Disengage the 5 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. B007YYGC01
      B007Z37 Remove in this Direction

      Disengage the 2 claws as shown in the illustration to remove the rear bumper assembly.

    5. w/ LEXUS Parking Assist-sensor System:


      1. Disconnect the connector.