FRONT WIPER MOTOR REMOVAL

PROCEDURE

  1. REMOVE FRONT WIPER ARM HEAD CAP

    1. E264921C01

      *a

      Protective Tape

      Using a screwdriver, disengage the 3 claws and remove the front wiper arm head cap.

      Tip:

      • Tape the screwdriver tip before use.

      • Use the same procedure for the RH side and LH side.

  2. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH

    1. E264922

      Remove the nut and windshield wiper arm and blade assembly LH.

  3. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH

    1. E264923

      Remove the nut and windshield wiper arm and blade assembly RH.

  4. REMOVE FRONT FENDER TO COWL SIDE SEAL LH

    1. E264924

      Disengage the 2 claws.

    2. E264925C01
      V100155

      Double-sided Tape

      Disengage the 3 guides, separate the double-sided tape and remove the front fender to cowl side seal LH as shown in the illustration.

  5. REMOVE FRONT FENDER TO COWL SIDE SEAL RH

    Tip:

    Use the same procedure as for the LH side.

  6. REMOVE FRONT NO. 2 SIDE PANEL PROTECTOR LH

    1. E264926

      Remove the clip.

    2. Disengage the claw and remove the front No. 2 side panel protector LH.

  7. REMOVE FRONT NO. 2 SIDE PANEL PROTECTOR RH

    1. E265021

      Remove the clip.

    2. Disengage the 2 claws and remove the front No. 2 side panel protector RH.

  8. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

    1. Remove the 2 clips.

      E264928

    2. Disengage the 6 claws and 3 guides as shown in the illustration.

      E264929

    3. Disengage the 8 guides and pull out the cowl top ventilator louver sub-assembly as shown in the illustration.

      E264930

  9. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    1. E264931

      Disengage the 2 clamps.

    2. Remove the 2 bolts.

    3. E264932C01

      *a

      Motor Grommet

      Disengage the motor grommet and remove the windshield wiper motor and link assembly as shown in the illustration.

      Note:

      Be careful not to damage the windshield when removing the windshield wiper motor and link assembly.

    4. E264933

      Disconnect the connector.

  10. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

    1. E264934C01

      *a

      Protective Tape

      *b

      Windshield Wiper Crank Pivot

      Using a screwdriver, separate the No. 1 windshield wiper link rod from the windshield wiper crank pivot of the windshield wiper motor and link assembly as shown in the illustration.

      Tip:

      Tape the screwdriver tip before use.

    2. E264935

      Remove the 3 bolts and windshield wiper motor assembly from the windshield wiper link assembly.

      Tip:

      If the windshield wiper motor assembly cannot be removed from the windshield wiper link assembly, turn the crank arm so that the windshield wiper motor assembly can be removed.