METER / GAUGE SYSTEM Hybrid System Indicator Malfunction

DESCRIPTION

A hybrid system indicator is adopted for this vehicle. In this circuit, the combination meter sub-assembly receives the hybrid system indicator level signal from the hybrid vehicle control ECU assembly via the CAN communication line. The combination meter sub-assembly controls the operation of the hybrid system indicator according to the hybrid system indicator level signal received from the hybrid vehicle control ECU assembly via the CAN communication line.

WIRING DIAGRAM

B005ZQXE35
*1 Hybrid Vehicle Control ECU
*2 Combination Meter Assembly
*3 CAN Communication Line

PROCEDURE


  1. CHECK CAN COMMUNICATION SYSTEM


    1. Check if CAN communication DTCs are output Click here. (w/ Central Gateway ECU)

    2. Check if CAN communication DTCs are output Click here. (w/o Central Gateway ECU)

      Result
      Result Proceed to
      CAN communication DTCs are not output. A
      CAN communication DTCs are output. (w/ Central Gateway ECU) B
      CAN communication DTCs are output. (w/o Central Gateway ECU) C

    B

    GO TO CAN COMMUNICATION SYSTEM Click here

    C

    GO TO CAN COMMUNICATION SYSTEM Click here

    A

  2. PERFORM ACTIVE TEST USING GTS (HV SYSTEM INDICATOR)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. Check the indicator light operation according to the values in the table below.

      Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      HV System Indicator Hybrid System Indicator MIN, -50, 0, 100, MAX -
      OK
      Hybrid system indicator indication is normal.
      Result
      Result Proceed to
      OK A
      NG (w/o Multi-information display) B
      NG (w/ Multi-information display) C

    B

    REPLACE METER CIRCUIT PLATE Click here

    C

    REPLACE COMBINATION METER SUB-ASSEMBLY Click here

    A

  3. READ VALUE USING GTS (HYBRID SYSTEM INDICATOR)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Data Test.

    5. Check the values by referring to the table below.

      Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Hybrid System Indicator Hybrid system indicator value/ Min.: -512, Max.: 511 (%) -512 to 511 (%) -
      OK
      Hybrid system indicator value displayed on the GTS is almost the same as hybrid system indicator indication.
      Result
      Result Proceed to
      OK (w/o Multi-information display) A
      OK (w/ Multi-information display) B
      NG C

    B

    REPLACE COMBINATION METER SUB-ASSEMBLY Click here

    C

    GO TO HYBRID CONTROL SYSTEM Click here

    A

  4. REPLACE METER CIRCUIT PLATE


    1. Replace the meter circuit plate with a new or a known good one Click here.

      OK
      The operation of the hybrid system indicator returns to normal.

    OK

    END

    NG

    REPLACE HYBRID VEHICLE CONTROL ECU ASSEMBLY Click here

  5. REPLACE COMBINATION METER SUB-ASSEMBLY


    1. Replace the combination meter sub-assembly with a new or a known good one Click here.

      OK
      The operation of the hybrid system indicator returns to normal.

    OK

    END

    NG

    REPLACE HYBRID VEHICLE CONTROL ECU ASSEMBLY Click here